It is always hot this time of year, but this year summer has been hotter than usual in the DFW area.
Traditionally one of the solutions to dealing with the summer heat is the cool enjoyment that a swimming pool can provide. That is not always possible this time of year—as pool water tends to heat up, oftentimes past the point of being refreshing.
Most of those who enjoy swimming pools prefer water temperature in the range of 80-90 degrees, with temperatures below 80 and above 90 being considered uncomfortable. With the water temperature in many full-sun pools now reaching the low-90’s, pool owners are looking for ways to lower the temperature of the water.
Following are some methods that have been used to lower the temperature of their pool water:
Fountains & waterfalls—Fountains and waterfalls lower the water temperature—as the water action that is created by fountains and waterfalls causes evaporation, which cools the water. This also tends to cause more water loss due to this evaporation. Operating the fountain or waterfall at night is most effective as the air temperature is cooler. If your pool is not equipped with a fountain or waterfall, aftermarket fountains are available that attach to the pool return.
Ice—Ice can also cool a pool, but it is really not a practical method of cooling pool water—as it takes an excessive amount of ice and the change is only temporary. According to an article in the Wall Street Journal, it would take 8,750 pounds of ice to lower the water temperature of a 20,000 gallon pool by 10 degrees. These numbers are fairly consistent with research done by Mythbusters—so you can see that ice is not a sensible method of cooling the water.
Drain & refill—A partial drain and refill of your pool water is another option, depending on your water source. This method definitely works, especially if your water source is from a well, as well water is typically much cooler this time of year than surface water. Denton and most other large municipalities in the north Texas area depend on surface water (lake water) as opposed to well water, but most water sources for pools outside of these municipalities are well water, making this option something to consider. One factor to consider before implementing this strategy is that you will have to rebalance your water chemistry, and also the fact that it is wasteful.
Shade the pool—Although it will not help you this summer, consider planting some trees around the pool, especially on the west side. But remember, if you choose deciduous trees, you will be cleaning leaves out of the pool in the fall.
Reversible heat pumps—Reversible heat pumps will either heat or cool pool water with the flip of a switch. Although they are fairly expensive and consume a considerable amount of power to operate, they are effective when it comes to cooling pool water.
Evaporative coolers—Evaporative coolers use evaporation to lower the temperature of your pool water. They are considerably less costly to purchase and operate than a heat pump, but they are not capable of being used as a heater in the winter as a heat pump is. They have been used in the Denton area in the last few years. Although there are many variables that alter the effectiveness of evaporative coolers (such as size of the cooler, pool size, ambient temperature, & humidity), oftentimes 5-10 degree temperature drops are attained.
Cooling the pool area—Another method of dealing with the heat is by using portable coolers for the pool area—they are typically electric and work well for a small area. An alternative to a portable cooler is misting the backyard area, similar to what many restaurant patios are effectively doing. More information on mist cooling can be found at www.mistcooling.com
As you can tell, there are quite a few options available for lowering the temperature of your pool water, some more practical than others. If you are interested in receiving a free evaluation & estimate on the installation of either a reversible heat pump or evaporative cooler, give us a call at (940)384-7665.